Positek H500

Positek

Part no.: Positek H500

Key Features

• CSA approved for potentially explosive dust atmospheres

• 0.5-9.5V or 4-20mA outputs

• ATEX variants of P502, P505 and P520 available

• Up to 160 deg range

Intrinsically safe H500 is CSA approved for use in potentially explosive dust atmospheres. The H500 is designed for industrial and scientific feedback applications and is ideal for OEMs seeking good sensor performance for arduous applications in hazardous areas.

The H500, like all Positek® sensors, is supplied with the output calibrated to the angle required by the customer, between 16 and 160 degrees and with full EMC protection built in. The sensor provides a linear output proportional with angle of rotation. There is a machined registration mark to identify the calibrated mid point.

Overall performance, repeatability and stability are outstanding over a wide temperature range. The H500 has long service life and environmental resistance with a rugged stainless steel body and shaft. The flange or servo mounting options make the sensor easy to install, it also offers a range of mechanical options. Environmental sealing is to IP67 depending.

Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier . Approved galvanic isolation amplifiers (G005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs.
The sensor can be installed with a cable length up to 1km between the sensor and the amplifier.

Datasheet Download

Part Builder

Drawing Download

Call us for more info at 856-727-9500

"*" indicates required fields

You may also be interested in:

Positek

E112

ATEX/IECEx approved to: Ex II 1G : Ex ia IIC T4 GA (Ta = -40°C to +80°C)
Sensor Mounting: 1/2" UNF ThreadSpring loaded plunger
Available in any measurement range from 0-5mm to 0-50mm
Sealed to IP67

Positek

G117

CSA approved to: Class I, Zone 0
Sensor Mounting: M5 Rod Eyes, Body Clamps or M5 ThreadsSpring loaded pushrod option available
Available in any measurement range from 0-5mm to 0-350mm
Sealed to IP67

Positek

H114

CSA approved to: Class I, Zone 0
Sensor Mounting: M5 rod eyes, body clamps or M5 threadsSpring loaded pushrod option available
Available in any measurement angle from 0-5mm to 0-800mm
Sealed to IP68 10bar, 100msw, 145psi(for 350bar sealing see S125)

Positek

X133

ATEX/IECEx approved to: Ex II 1G : Ex ia IIC T4 GA (Ta = -40°C to +80°C)
Sensor Mounting: Flange or body clampsSpring loaded pushrod option available
Available in any measurement range from 0-51mm to 0-100mm(for 2-50mm range see P103)
Sealed to IP65/67 depending on connector/cable option

POSITAL UCD…H200 Through-hole Encoder

Over the past 15 years Everight Position has worked with a lot of unique sensors. But one of our favorites is the POSITAL UCD…H200. When looking back there are two things that make this sensor so special.

Introduction to Intrinsically Safe Sensors

Intrinsically safe (IS) sensors are unable to produce a spark strong enough to cause ignition. Learn how this is accomplished and design considerations when using IS sensors.

Robust IncOders that Are Right for Your Application

Zettlex IncOders are non-contact devices for precision angle measurement. They work like a transformer, using an inductive technique. IncOders may be considered as an inductive angle encoder. IncOders are ideally suited to harsh environments – where potentiometers, optical or capacitive devices may prove unreliable.