Part no.: M114
• ATEX/IECEx approved for mining
• Sensor Mounting: M5 rod eyes, body clamps or M5 threadsSpring loaded pushrod option available
• Available in any measurement angle from 0-5mm to 0-800mm
• Sealed to IP68 10bar, 100msw, 145psi(for 350bar sealing see S125)
The intrinsically safe 10 bar M114 is an ATEX and IECEx approved affordable, durable, high-accuracy position sensor.
The M114, like all Positek sensors, provides a linear output proportional to displacement. Each unit is supplied with the output calibrated to the travel required by the customer, from 0-5mm to 0-800mm and with full EMC protection built in. The sensor is very robust, the body and push rod being made of stainless steel for long service life and environmental resistance. Derived from the popular M101, the M114 has been designed for applications where the sensor may be completely submerged in water up to a pressure of 10Bar, but good sensor performance and cost are still important.
Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier. Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs.
The sensor can be installed with a cable length up to 1km between the sensor and the amplifier.
"*" indicates required fields
Positek
Positek
Positek
Positek
Technical Note: Intrinsically Safe vs. Inherently Safe Sensors
Intrinsically safe (IS) sensors are designed to operate safely in hazardous areas where there is a risk of explosion. IS sensors limit the amount of electrical and thermal energy that can be released in the event of a fault, to a level below that which is capable of igniting flammable gases, vapors, or dust.
Expanded VLP Encoder Series Offers Control Engineers New Sensing Options
Everight Position is pleased to announce the addition of four new sizes of Netzer’s two-plate VLP rotary encoder amongst other improvements. Based on the success of the VLP-60 and VLP-100, the new options include the VLP-80, VLP-140, VLP-170 and VLP-247.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (i.g. controller) and a slave (i.g. sensor).
Positek’s portfolio includes a range of high-accuracy linear sensors specifically designed for use in submersible applications. Made from marine grade stainless steel and offering the reliability that is not possible from a submersible LVDT or linear potentiometer, our sensors have served a host of different industries such as wastewater and offshore oil drilling. Another use […]