Part no.: X112
• ATEX/IECEx approved to: Ex II 1G : Ex ia IIC T4 GA (Ta = -40°C to +80°C)
• Sensor Mounting: 1/2" UNF ThreadSpring loaded plunger
• Available in any measurement range from 0-5mm to 0-50mm
• Sealed to IP67
The intrinsically safe X112 is ATEX and IECEx approved for use in potentially explosive gas/vapour atmospheres. It is designed for gauge head positioning in industrial and scientific applications and is ideal for OEMs seeking good sensor performance for arduous applications in hazardous areas. The X112, like all Positek sensors, provides a linear output proportional to displacement. Each sensor is supplied with the output calibrated to the travel required by the customer, from 0-5mm to 0-50mm and with full EMC protection built in.
Overall performance, repeatability and stability are outstanding over a wide temperature range. The sensor is very robust, the body and plunger being made of stainless steel for long service life and environmental resistance.
The plunger is spring loaded with a domed end. The X112 is easy to install with a long ½ inch UNF mounting thread and is supplied with two lock nuts for positioning. Environmental sealing is to IP67.
Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier . Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs.
The sensor can be installed with a cable length up to 1km between the sensor and the amplifier.
"*" indicates required fields
Positek
Positek
Positek
How-to: 2 Point Operation of an Open Collector Switch Output
In this example, the switch point has been set to ‘Full Alarm’. By setting the switch point to 90% with an 80% hysteresis, the switch will come on at 90% and switch off at 10%.
There is a lot of talk about ‘data’ these days. But what can be just important as the data is how you communicate it.
For applications where sudden movements, shocks, and vibrations are likely to be encountered, it is important to have sensors with fast response and a clean signal output. POSITAL’s dynamic inclinometers combine two measurement principles using two different MEMS sensors: a 3D acceleration sensor and a 3D gyroscope.
Application Note: Rotary Encoders for Azimuth and Elevation Feedback in Vision Gimbals
Vision gimbals are critical components in various applications, including unmanned aerial vehicles (UAVs), robotics, and surveillance systems. Used in IR, LIDAR, visible light and other frequencies, they stabilize cameras or sensors, providing smooth and accurate footage or data acquisition regardless of platform movement.