G112

Positek

Part no.: G112

Key Features

• CSA approved to: Class I, Zone 0

• Sensor Mounting: 1/2" UNF ThreadSpring loaded plunger

• Available in any measurement range from 0-5mm to 0-50mm

• Sealed to IP67

The intrinsically safe G112 is CSA approved for use in potentially explosive gas/vapour atmospheres. It is designed for gauge head positioning in industrial and scientific applications and is ideal for OEMs seeking good sensor performance for arduous applications in hazardous areas. The G112, like all Positek sensors, provides a linear output proportional to displacement. Each sensor is supplied with the output calibrated to the travel required by the customer, from 0-5mm to 0-50mm and with full EMC protection built in.

Overall performance, repeatability and stability are outstanding over a wide temperature range. The sensor is very robust, the body and plunger being made of stainless steel for long service life and environmental resistance.

The plunger is spring loaded with a domed end. The G112 is easy to install with a long ½ inch UNF mounting thread and is supplied with two lock nuts for positioning. Environmental sealing is to IP67.

Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier . Approved galvanic isolation amplifiers (G005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs.

The sensor can be installed with a cable length up to 1km between the sensor and the amplifier.

Datasheet Download

Part Builder

Drawing Download

Call us for more info at 856-727-9500

"*" indicates required fields

You may also be interested in:

Positek

P117

Body Diameter: 19mm
Sensor Mounting: M5 Rod Eyes, Body Clamps or M5 ThreadsSpring loaded pushrod option available
Available in any measurement range from 0-5mm to 0-350mm
Sealed to IP67

Positek

M103

ATEX/IECEx approved for mining
Sensor Mounting: Flange or Body ClampsSpring loaded pushrod option available
Available in any measurement range from 0-2mm to 0-50mm (for 51-100mm range see P133)
Sealed to IP65/67 depending on connector/cable option

Positek

P100

Body Diameter: 35mm
Sensor Mounting: In-Cylinder Mounting
Any stroke from 0-5mm to 0-800mm (e.g. 305mm)
IP65 (connector) / IP67 (cable)

Positek

S125

Body Diameter: 40mm
Sensor Mounting: M8 rod eyes, body clamps or M8 threadsSpring loaded pushrod option available
Available in any measurement angle from 0-5mm to 0-800mm
Sealed to IP68 350bar, 3500msw, 5000psi

MEMS Inclinometer Specifications

Inclinometers, also called tilt sensors, clinometers, or slope sensors, are designed to measure the angle of an object with respect to the force of gravity. These tilt or level meters determine the pitch and/or roll angle and output these values via the appropriate electrical interface.

Potentiometers That Make Sense for Sensing

Despite their perceived simplicity, potentiometers can still be an appropriate option in today’s ever-complicated automation industry. Fundamentally a variable resistor, modern potentiometers also offer more traditional outputs such as voltage and current which are common to more expensive sensors.

Netzer VLX

Encoders that perform in the most important application: Yours!

Dynamic Inclinometers

For applications where sudden movements, shocks, and vibrations are likely to be encountered, it is important to have sensors with fast response and a clean signal output. POSITAL’s dynamic inclinometers combine two measurement principles using two different MEMS sensors: a 3D acceleration sensor and a 3D gyroscope.