Positek

E114

Part no.: E114

Key Features

• ATEX/IECEx approved to: Ex II 1G : Ex ia IIC T4 GA (Ta = -40°C to +80°C)

• Sensor Mounting: M5 rod eyes, body clamps or M5 threadsSpring loaded pushrod option available

• Available in any measurement angle from 0-5mm to 0-800mm

• Sealed to IP68 10bar, 100msw, 145psi(for 350bar sealing see S125)

The intrinsically safe 10 bar E114 is an ATEX and IECEx approved affordable, durable, high-accuracy position sensor.

The E114, like all Positek sensors, provides a linear output proportional to displacement. Each unit is supplied with the output calibrated to the travel required by the customer, from 0-5mm to 0-800mm and with full EMC protection built in. The sensor is very robust, the body and push rod being made of stainless steel for long service life and environmental resistance. Derived from the popular E101, the E114 has been designed for applications where the sensor may be completely submerged in water up to a pressure of 10Bar, but good sensor performance and cost are still important.

Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier. Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs.

The sensor can be installed with a cable length up to 1km between the sensor and the amplifier.

Call us for more info at 856-727-9500

  • Hi, My name is

  • and I’m interested in the

  • You can reach me by email at

  • or phone at

  • Message

  • This field is for validation purposes and should be left unchanged.
You may also be interested in:

Positek

G112

  • CSA approved to: Class I, Zone 0
  • Sensor Mounting: 1/2" UNF ThreadSpring loaded plunger
  • Available in any measurement range from 0-5mm to 0-50mm
  • Sealed to IP67

Positek

H603

  • Single axis
  • Up to 160°
  • Voltage or Current interface
  • IP67

Positek

X005

  •  Provides isolation between the amplifier power supply, the hazardous area and the X005 output signal
  • Input power supply range of 12 to 30 volts DC
  • Factory configured to either 0.5 to 9.5V or 4-20mA
  •  Bandwidth of 4.7kHz, making it ideal for servo control loops.

Positek

G103

  • CSA approved to: Class I, Zone 0
  • Sensor Mounting: Flange or Body ClampsSpring loaded pushrod option available
  • Available in any measurement range from  0-2mm to 0-50mm (for 51-100mm range see P133)
  • Sealed to IP65/67 depending on connector/cable option
Blog:

MEMS Inclinometer Specifications

Inclinometers, also called tilt sensors, clinometers, or slope sensors, are designed to measure the angle of an object with respect to the force of gravity. These tilt or level meters determine the pitch and/or roll angle and output these values via the appropriate electrical interface.

Potentiometers That Make Sense for Sensing

Despite their perceived simplicity, potentiometers can still be an appropriate option in today’s ever-complicated automation industry. Fundamentally a variable resistor, modern potentiometers also offer more traditional outputs such as voltage and current which are common to more expensive sensors.

Spine Surgery Robot

Spinal surgery robot with advanced robotic guided technologies supports high requirements of predictable surgical procedures.

View Our Case Studies and Industries

Learn more about how Everight Position is helping to power leading technology in a variety of industries.